Parking Assist Light Installation
The parking assist light informs drivers entering the hallway when to stop via a green illuminated light bar. This section walks through the installation in its standard location; however, the power cable is long enough to accommodate any location along the hallway on either side.
The following components are needed to complete this section:
Table 10: Parking Assist Light Components
| Lion Power PN | Description | Qty | Notes |
|---|---|---|---|
| 102094 | BAR, LIGHT, LED, RGB, 260mm | 1 | Includes mounting brackets |
| 102258 | SCREW, SELF TAPPING, #8 x 1.5in, PH | 4 | |
| 102280 | CABLE, M12-A, 5-PIN, MALE TO FEMALE,<br>STRAIGHT, 15m | 1 | |
| 102324 | SLEEVE, 1” PLASTIC | 4 | Used if mounting to<br>block/brick/concrete wall |
Fence Post-Mounted Position and Routing
Figure 103: Parking Assist Light Standard Location
Figure 104: Parking Assist Light Mounting Position
Figure 105: Parking Assist Light Attachment
Figure 106: Standard Parking Assist Light Cable Routing
Wall-Mounted Position and Routing
The location of the wall-mounted light should roughly 3-6” directly above the light curtain cover as shown in Figure 107. The same fastener can be used from the previous section, with the addition of the 1” plastic sleeve into the block/brick/concrete. The cable should be routed as laid out in Figure 108.
Figure 107: Wall Mounted Parking Light
Figure 108: Wall-Mounted Parking Light Cable Route