Skip to main content

Operator Pressure Pad Installation

Table 12: Operator Pad Components

Lion Power PNDescriptionQtyNotes
101990 or<br>103436MAT, SAFETY, 24INx24IN, 3 PIN M8<br>CONNECTOR, MALE/FEMALE1103436 includes an<br>integrated/molded outer trim
101991KIT, TRIM, PERIMETER, 24x2414 plastic corners, 4 aluminum edges
102741CORNER, WIRE-EXIT, OPERATOR MAT1Custom Wire-Exiting Corner
101993CABLE, M8, 3-PIN, MALE TO FEMALE,<br>STRAIGHT, 2m2Connects operator pad to LV panel
102324SLEEVE, PLASTIC, 1”4Securement of corner trim pieces
102323SCREW, CONCRETE, 0.187"x1.25"4Securement of corner trim pieces

The operator pressure pad is installed to the ground using the following steps:

  1. Measure the pad from the primary rack as shown in Figure 116.

  2. If using the new 103436 molded trim operator mat, the aluminum trim kit is not needed, and you can proceed to step 5.

  3. Install the 4 aluminum edges and 3 of the plastic corners of trim kit around the pad and mark the holes at each corner with a marker as shown in Figure 117. The custom wire-exit corner piece (102741) should be installed in the front left corner closest to the fencing.

  4. Remove the pad and trim kit.

  5. Drill 1.5” deep holes at each corner hole location using a 5/16” concrete drill bit.

    • a. If using the new 103436 molded trim kit, ensure you drill through the rubber molded edge and not into the main mat.

  6. Tap the plastic sleeves into the new holes.

  7. Reinstall the pressure pad and trim kit, lining up the trim kit holes with the newly drilled holes.

  8. Secure the entire assembly using the concrete screws at each corner as shown in Figure 118.

  9. Connect the QTY 2 – M8 cables to the pressure pad and route up to the side of the main LV box as shown in Figure 119.

Figure 116: Pressure Pad Location from Rack 1 (101990 shown)

Figure 117: Pressure Pad Trim Kit Drilling Locations

Figure 118: Pressure Pad Installation onto Ground

Figure 119: Pressure Pad Cable Routing (2x M8 Cables)